Panasonic BB-HCM331A - Manual (Page 92)

Operating Instructions
92
2.20 Buffering or Transferring Images by Alarm
Signal
The Image Buffer/Transfer page allows you to enable image buffer/transfer by E-
mail or FTP.
Note
If you are recording images to the SD memory card, refresh interval slows
down.
1. Click [Buffer/Transfer] on the Setup page.
2. Click [No.] to enable buffer/transfer.
3. Check [Enable Image Buffer/Transfer], select [Alarm 1 or 2] for trigger, select
[Rising: GND to Open (High).] or [Falling: Open (High) to GND.] and click
[Next>].
Note
If you click [Save], all buffered images on the SD memory card are deleted.
• Click [Delete Buffered Images] to delete this buffered images.
• Click [Save] to save the settings.
• Clicking [Cancel] takes you back to the Image Buffer/Transfer page without
saving changes.