Pride Mobility LEGEND CLASSIC XL-8 - Manual (Page 31)

31
Legend Classic XL-8 www.pridemobility.com
V I I I . D I S A S S E M B L Y A N D A S S E M B L Y
DISASSEMBLY
You can disassemble the scooter into seven pieces: the seat, the front section, the rear section, the rear shroud, the
basket, and the batteries. See figure 18. No tools are required to disassemble or assemble your scooter. Always
disassemble or assemble your scooter on a level, dry surface with sufficient room for you to work and move
around—about 1.5 meters (five feet) in all directions. You may need assistance to lift some of the scooter components.
WARNING! Lifting weight beyond your physical capability may result in personal injury.
Ask for assistance when necessary while disassembling or assembling your scooter.
SEAT
REAR SHROUD
REAR SECTION
BATTERIES
BASKET
FRONT SECTION
Figure 18. The Legend Classic XL-8 Disassembled
To disassemble your scooter:
1. Place the manual freewheel lever in the drive position.
2. Lift the seat up and off the scooter.
3. Gently pull the shroud up and off of the rear section of the
scooter.
4. Disconnect the battery strap.
5. Unplug both T-handle battery harnesses. See figure 19.
6. Unplug the front-to-rear harness. See figure 19.
WARNING! Failure to unplug both T-handle
battery harnesses and the front-to-rear
harness prior to separating the front and
rear sections could result in permanent
damage to the scooter.
Figure 19. Harness Connections
FRONT-TO-REAR HARNESS
T-HANDLE BATTERY HARNESSES