Pioneer DV-575A - Manual (Page 46)

Additional information 08
46
En
Note
• Using the 16:9 (Wide) setting with a
standard 4:3 TV, or either of the 4:3 settings
with a widescreen TV, will result in a
distorted picture.
Setting the TV system
(Except DV-575A, DV-578A)
The default setting of this player is AUTO , and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO . If you experience picture distor-
tion with some discs, set the TV system to
match your country or region’s system. Doing
this, however, may restrict the kinds of disc you
can watch. The table below shows what kinds
of disc are compatible with each setting
(
AUTO , PAL and NTSC ).
1 If the player is on, press STANDBY/
ON to switch it to standby.
2 Using the front panel controls, hold
down then press STANDBY/ON to
switch the TV system.
The TV system changes as follows:
• AUTO NTSC
• NTSC PAL
• PAL AUTO
Note
• You have to switch the player into standby
(press STANDBY/ON ) before each
change.
Resetting the player
Use this procedure to reset all the player’s
settings to the factory default.
1 Switch the player into standby.
2 Using the front panel buttons,
hold down the (stop) button and press
STANDBY/ON to switch the player back
on.
All the player’s settings are now reset.
Power reset
Use this procedure to switch the power off if
the player is unresponsive to any control from
the front panel or remote.
1 Press and hold the front panel
STANDBY/ON for 10 seconds.
When the power is completely off, you cannot
use the remote to switch it back on again. Use
the front panel
STANDBY/ON button.
Disc Player setting
Type Format NTSC PAL AUTO
DVD/
Super
VCD NTSC NTSC PAL NTSC
PAL NTSC PAL PAL
Video CD NTSC NTSC PAL NTSC
PAL NTSC PAL PAL
CD/SACD
no disc — NTSC PAL NTSC or
PAL
DV575A KU_Mid.book 46 ページ ２００４年２月６日 金曜日 午後２時３８分