Pioneer HDD MULTIMEDIA AV NAVIGATION SERVER AVIC-Z1 - Manual (Page 15)

13
Chapter 2
How to Use
the Na
viga
tion System a
n
d Na
mes of t
h
e Pa
rts
When Using the Navigation Sys-
tem for the First Time
The navigation system cannot detect the location
correctly if the initial learning is not complete.
The correct positioning can be attained after driv-
ing a certain distance. (The AV source can be
used normally regardless of the initial learning
status.)
When the vehicle starts to run, the 3D Hybrid
Sensor’s initial learning automatically starts.
Until the 3D Hybrid Sensor’s initial learning is
complete, the positioning is performed by GPS
satellites so the location of your vehicle may not
be very accurate. This is not an error. When the
initial learning is complete, the location of your
vehicle can be detected at high accuracy.
❒ When an error message appears during the
initial learning, refer to “Message and how to
react to them” in the Operation Manual.
Selecting a Source by the AV
button
1
Turn the ignition switch (ACC) ON.
The navigation system’s power supply comes
on.
2
After the navigation system starts, press
the AV button to switch the screen.
Navigation map screen changes to audio
source screen.
3
Press the AV button to turn the audio
source on.
4
Press the AV button to select a source.
Press the AV button repeatedly to switch
between the following sources:
[CD/ROM (MP3)/DVD] (built-in DVD drive)
— [MUSIC LIBRARY] (HDD player) — [FM]
(FM tuner) — [AM] (AM tuner) — [XM] (XM
tuner) — [SIRIUS] (SIRIUS tuner) — [iPod]
(iPod) — [M-CD] (multi-CD) — [TV] (televi-
sion) — [AV INPUT] (video input) — [AUX]
(Auxiliary equipment) — [EXT 1] (external
unit 1) — [EXT 2] (external unit 2)
❒ Press and hold the AV button to turn the
source off.
❒ In the following cases, the sound source can-
not be used:
— When a unit corresponding to each source
is not connected to this product.
— When no disc is set in this navigation sys-
tem.
— When no magazine is set in the multi-CD
player.
— When no magazine is set in the multi-DVD
player.
— When [AUX Input] (auxiliary input) is set to
off (refer to Operation Manual).
— When [AV Input] (video input) is not set to
[Video] (refer to Operation Manual).
❒ External unit refers to a Pioneer product (such
as one available in the future) that, although
incompatible as a source, enables control of
basic functions by this product. Two external
units can be controlled by this product. When
two external units are connected, the product
allocates them to external unit 1 or external
unit 2.
❒ When the [Auto ANT] mode is set to
[Radio], the vehicle’s antenna can be stowed
by following the instructions below.
— Change the source from radio (AM or FM)
to another source.
— Turn the source off.
— Turn off the ignition switch (ACC OFF).
If the [Auto ANT] mode is set to [Power], the
vehicle’s antenna can be stowed only when
the ignition switch is turned off (ACC OFF).
➲ [Auto ANT] ➞ Operation Manual
Adjusting the Volume
• Use the VOL (/) button to adjust the
audio sound level.
Press the VOL (/) button to increase or
decrease the volume.
❒ To adjust the navigation volume, go to the
navigation menu.
➲ Navigation volume adjustment ➞ Opera-
tion Manual