Pioneer XW-NAS5 - Manual (Page 15)

Bluetooth® ADAPTER for Wireless Enjoyment of Music 04
15
En
English
Français
Deutsch
Nederlands
Italiano
Español
1 Switch the unit into standby and connect
Bluetooth ADAPTER to the ADAPTER PORT
located in the rear panel.
2 Press  STANDBY/ON.
3 Press INPUT to switch the unit to ‘ ’.
1
When pairing has not been performed,
‘
’ is displayed.
Setting the PIN code
Set this unit’s PIN code to the same setting as
that for the Bluetooth wireless technology
device used. Supported PIN code setting
values include 0000, 1234 or 8888.
• Default setting: 0000
1 Switch the unit into standby.
2 Press and hold  for three seconds.
The new PIN code will be displayed, indicating
that the PIN code has been changed.
Repeat step 2 until the PIN code is reset to the
value desired.
Pairing Bluetooth ADAPTER and
Bluetooth wireless technology
device
“Pairing” must be done before you start
playback of Bluetooth wireless technology
content using Bluetooth ADAPTER. Make sure
to perform pairing first time you operate the
system or any time pairing data is cleared.
“Pairing” is the step necessary to register
Bluetooth wireless technology device to enable
Bluetooth communications.
2 For more details,
see also the operating instructions of your
Bluetooth wireless technology device.
1 When ‘ ’ lights, press .
‘ ’ will flash, and the unit will enter the
pairing standby mode.
2 Switch on the Bluetooth wireless
technology device that you want to make
pairing, place it near the system and set it
into the pairing mode.
Pairing begins.
3 Check to see that the Bluetooth ADAPTER
is detected by the Bluetooth wireless
technology device.
lights when Bluetooth wireless
technology device is connected.
lights when Bluetooth wireless
technology device is not connected. In this
case, perform the connection operation from
the side of the Bluetooth wireless technology
device.
Note
1 When the Bluetooth ADAPTER is not plugged in the ADAPTER PORT, cannot be selected even if INPUT is pressed.
PRESET PRESET
ENTER
SLEEP WAKE
UP
BASS/
TREBLE
TUNE
2 • Pairing is required when you first use Bluetooth wireless technology device and Bluetooth ADAPTER.
• To enable Bluetooth communication, pairing should be done with both of your system and Bluetooth wireless technology
device.
PRESET PRESET
ENTER
SLEEP WAKE
UP
BASS/
TREBLE
TUNE
XW-NAS5_CUXJ.book 15 ページ ２０１０年１月２６日 火曜日 午後５時０分