Panasonic DMR E50 - Manual (Page 75)

75
Troubleshooting guide (continued)
Play
Remote control
Play fails to start even when [ 1 ]
(21) is pressed.
Play starts but then stops
immediately.
“NO READ”, “UN SUPPORT”,
“NO DISC” or “NO PLAY” appears
on the unit’s display.
≥ Insert the disc correctly with the label facing up. (page 20)
≥ This unit cannot play discs other than DVD-RAM, DVD-R, DVD-Video, Video CD, CD and MP3
disc. (page 10)
≥ The disc is dirty. Clean it. (page 69)
≥ The disc may be badly scratched. (page 69)
≥ You inserted a blank DVD-RAM or DVD-R.
No response when buttons
pressed. ≥ If “ ” appears on the television,
the operation is prohibited by the unit or disc.
≥ If the unit is not operating at all, press [ , TIMER] (12) to switch the unit to standby, then press
[ , TIMER] (12) again to turn the unit on. The unit may not be operating correctly due to
lightning, static electricity, or some other external factor.
≥ The Child Lock function is activated. (page 54)
A title or chapter doesn’t play
when it is selected. ≥ Some titles and chapters on DVD-Video are not played when you have changed the ratings
level. (page 62)
Picture distorted during search. ≥ Some distortion is normal.
Alternative soundtrack and
subtitles cannot be selected. ≥ The languages are not recorded on the disc.
≥ You may have to use the disc’s menus to select languages.
Soundtrack/subtitle language not
the one selected with the SETUP
menus. ≥ The language is not recorded on the disc. (page 59)
No subtitles. ≥ Subtitles are not recorded on the disc.
≥ Turn the subtitles on. (page 51)
Angle cannot be changed. ≥ This function depends on software availability. Angles can only be changed during scenes where
different angles are recorded (“ ” appears on the display).
You have forgotten your ratings
password. ≥ Return the unit's settings to the initial state (factory setting).
With the tray open, keep pressing [
: / 6 ] and [ 5 / 9 ] (45) on the main unit
simultaneously for 5 or more seconds.
The remote control doesn’t work. ≥ The unit is on standby to make a timer recording (“ ” on the unit’s display is on). (page 32)
≥ [DVD, TV] (15) is not switched to “DVD”.
Switch to “DVD” when operating this unit. (page 8)
≥ The remote control code is wrong.
Change to the correct code. (page 63)
≥ The batteries are depleted. Replace them with new ones. (page 8)
≥ Point the remote control at the remote control sensor on the main unit. (page 8)
≥ Remove obstacles from between the remote control and main unit.
≥ The Child Lock function is activated. (page 54)
Cannot operate the television. ≥ The remote control code is wrong.
Change to the correct code. Some televisions cannot be operated even if you change the code.
(page 9)
≥ [DVD, TV] (15) is not switched to “TV”.
Switch to “TV” when operating the television. (page 9)