Pioneer Industrial VSX-94-TXH - Manual (Page 13)

Additional information 05
13
En
Chapter 5:
Additional information
Troubleshooting
Refer to the following information if you come up with a problem. Operational mistakes may be misunderstood as
mechanical problems. Also, the cause of a problem may lie elsewhere other than this receiver. Check your audio
components on the network as well as your USB memory device. If problems persist or if the following information
does not provide you with an appropriate remedy, consult with your nearest Pioneer service center.
Symptoms Causes Remedies Refer to
Cannot access the network. The LAN cable is not firmly connected. Firmly connect the LAN cable. 3
The router is not switched on. Switch on the router. —
Internet security software is currently installed in
the connected component. There are cases where a component with
Internet security software installed cannot be
accessed. —
The audio component on the network which has
been switched off is switched on. Switch on the audio component on the network
before switching on this receiver. —
Playback does not start
while
‘Connecting...’
continues to be displayed.
The component is currently disconnected from
this receiver or the power supply. Check whether the component is properly
connected to this receiver or the power supply. —
The PC or Internet radio is
not properly operated. The corresponding IP address is not properly set. Switch on the built-in DHCP server function of
your router, or set up the network manually
according to your network environment.
10
The IP address is being automatically
configured. The automatic configuration process takes time.
Please wait. —
The audio files stored on
components on the network,
such as a PC, cannot be
played back. Windows Media Player 11 is not currently
installed on your PC. Install Windows Media Player 11 on your PC. 4
Audio files were recorded in formats other than
MP3, WAV (LPCM only), MPEG-4 AAC, FLAC,
and WMA. Play back audio files recorded in MP3, WAV
(LPCM only), MPEG-4 AAC, FLAC, or WMA. Note
that some audio files recorded in these formats
may not be played back on this receiver. —
Audio files recorded in MPEG-4 AAC or FLAC are
being played back on Windows Media Player 11
or Windows Media Connect. Audio files recorded in MPEG-4 AAC or FLAC
cannot be played back on Windows Media Player
11 or Windows Media Connect. Try using
another server. Refer to the
operation
manual
supplied
with your
server.
The component connected to the network is not
properly operated. Check whether the component is affected by
special circumstances or is in the sleep mode.
Try rebooting the component if necessary. —
The component connected to the network does
not permit file sharing. Try changing the settings for the component
connected to the network. —
The folder stored on the component connected
to the network has been deleted or damaged. Check the folder stored on the component
connected to the network. —
Cannot access the
component connected to
the network. The component connected to the network is not
properly set. If the client is automatically authorized, you need
to enter the corresponding information again.
Check whether the connection status is set to
“Do not authorize”. —
There are no playable audio files on the
component connected to the network. Check the audio files stored on the component
connected to the network. —
VSX_94TXH_net.book Page 13 Monday, May 14, 2007 3:39 PM