Parts and their functions, Rear panel, A = > ? b d c – Panasonic AJ-SD755 User Manual
Page 14
14
Rear panel
<
Fan
This fan is used to cool down the VTR.
If, for any reason, the fan stops, “E-10” will appear
on the counter display.
=
SIGNAL GND terminal
This is connected to the signal ground terminal on
the component connected to this VTR in order to
minimize noise. It is not a safety ground.
>
ANALOG COMPONENT VIDEO OUT connectors
The analog component video signals are output
through these connectors.
?
ANALOG COMPOSITE VIDEO OUT connectors
The analog composite video signals are output
through these connectors.
The waveform monitor (WFM) signal can be output
from the VIDEO OUT 2 connector.
It can be selected using setup menu No. 00 (WFM
SEL).
Video signals containing superimposed information
can be output through the VIDEO OUT 3 connector.
Whether the superimposing is to be set ON or OFF
is selected using the SUPER switch W on the front
panel.
@
RS-232C connector
A personal computer or other component can be
connected to this connector to operate the VTR.
Parts and their functions
A
PARALLEL REMOTE connector
This connector is used when the VTR is to be
operated by an external component.
B
ANALOG AUDIO OUT connectors
The analog audio signals are output through these
connectors.
C
MONITOR OUT connectors
During playback, the PCM audio signals (CH1/CH2)
or playback signals from the CUE track are output
through these connectors.
<Note>
Noise may appear on the CUE signal at the instant
recording is started.
D
SDTI input and output connectors (optional)
When the SDTI board (AJ-YAC930G, optional
accessory) is installed in this VTR, digital data can
be input and output using the SDTI (Serial Data
Transport Interface) format.
IEEE1394 digital input/output connector
(optional)
Use of an digital video interface board (AJ-
YAD755G, optional accessory) enables input/output
interfacing of the digital signals with the IEEE1394
standard.
PUSH
PUSH
PUSH
AC IN
SIGNAL
GND
AES/EBU
ANALOG
CH1/2
IN
Y
VIDEO
VIDEO
OUT
SERVICE ONLY
REMOTE IN/OUT
CH1
CH2
AUDIO
IN
ENCODER REMOTE
RS-232C
PARALLEL
REMOTE
OUT
IN
REF VIDEO
IN
ON
OFF
PB
PR
Y
1
2
(WFM)
3
(SUPER)
PB
PR
CH1/2
OUT
REMOTE
75
Ω
ON
OFF
75
Ω
ANALOG
TC
IN
TC
OUT
MON
L
MON
R
CH1
CH2
AUDIO
OUT
OPTION 2
OPTION 1
<
@ A
=
> ?
B
D
C
SDTI
IN
OUT
1
2
SDI
IN
OUT
ACTIVE
THROUGH
1
2
3
(SUPER)