Panasonic BT-S950P - Manual (Page 4)

4
CONTROLS AND FEATURES
Front
<Front Panel>
3 4 5 6
11 12 13 14
7 8 9 10
POWER
UNDER
SCAN
PULSE
CROSS MONO BLUE
LINE A
LINE B
EXT
SYNC
NTSC PAL V.HOLD
NTSC
PAL
4:3
16:9
CONTRAST BRIGHT CHROMA PHASE VOLUME
1 Tally lamp
Indicates that a control signal is being received. The tally
lamp functions when the control signal is input to the
TALLY/REMOTE terminal on the rear panel.
2 Speaker
A built-in speaker is located inside the left side panel.
3 VOLUME control
Adjusts the speaker volume.
4 V.HOLD control
Use a small-bladed screwdriver to adjust the image’s
vertical stability.
5 Picture control section
PHASE, CHROMA, BRIGHT and CONTRAST controls
are available.
The standard setting mode can be obtained by setting
each control to the center click position. To adjust a
setting, insert a small-bladed screwdriver into the space
around the knob and turn it to the desired position.
When adjusting, use the small-bladed screwdriver and
insert it into the control hole around the required control
knob.
Ⅵ PHASE control
Adjusts picture hue.
Ⅵ CHROMA control
Adjusts picture color density.
Ⅵ BRIGHT control
Adjusts picture brightness.
Ⅵ CONTRAST control
Adjusts picture contrast.
Notes:
* The PHASE control is effective only in the NTSC color
system mode.
* The standard CHROMA setting can be adjusted to suit
the NTSC or PAL color system.
6 LINE A/B switch
Select the video signal input to the video input terminals
on the rear panel.
A (
G ): Selects the video signal input to LINE A terminal.
B ( g ): Selects the video signal input to LINE B terminal.
Note:
* LINE B terminals include both S-VIDEO (Y/C) and
composite VIDEO terminals. S-VIDEO inputs have
priority.
7 EXT SYNC switch
Selects internal sync or external sync.
When using with the external sync, input the sync signal to
the EXT SYNC terminal on the rear panel.
(
G ) : Internal sync
( g ) : External sync
8 NTSC/PAL switch
Selects the NTSC or PAL color system.
NTSC (
G ) : For NTSC color system.
PAL ( g ) : For PAL color system.
9 4 : 3/16 : 9 switch
Selects the aspect ratio (4:3 or 16:9) of the picture
displayed on the screen.
(
G ) : 4:3
( g ) : 16:9
Note:
* When a 4:3 picture is viewed in the 16:9 mode, the size
of the image is reduced vertically.
10 POWER switch/POWER indicator
Press this switch to turn the power on or off.
ON (
g ) : Power is turned on and the power indicator
lights.
OFF ( G ) : Power is turned off and the power indicator
goes off.
Note:
* If the battery expires while the monitor is operated with
DC power supply (the voltage level drops), the green
indicator changes to orange, then to red. When the
POWER indicator changes to red, the power
automatically goes off. Make sure you switch off the
power before replacing the battery.
POWER
UNDER SCAN PULSE CROSS MONO BLUE
EXT SYNC LINE A LINE B
NTSC PAL V.HOLD
NTSC PAL 4:3 16:9
CONTRAST BRIGHT CHROMA PHASE VOLUME
S950 BT-
1
2
LCT1182-001A-H (EN)Letter Size 02.3.15, 12:24 PM Page 4 Adobe PageMaker 6.0J/PPC