Piega Owners Manual Loudspeaker - Manual (Page 9)

PIEGA User Manual
Connecting the Loudspeakers
The terminal for single wiring applications is provided at the back of the loudspeaker. This is used for connect-
ing standard loudspeaker cables with banana plugs or with a lead. Ideally, PIEGA loudspeakers should be con-
nected with the OPUS 3 or OPUS 1 loudspeaker cable which is available as an accessory.
Connection:
Ensure that the electronic components are switched
off before making the connection.
PIEGA loudspeakers must only be connected to elec-
tronic components with the amplifi er outputs recom-
mended by PIEGA. Observe the specifi cations of the
amplifi er manufacturer. Contact your dealer if you are
unsure whether the connection is permissible.
The loudspeakers have an impedance of 4 Ohms and
can therefore be connected to any standard amplifi er.
Contact your specialist dealer concerning this.
Connect the PIEGA loudspeaker to your amplifi er or
receiver using suitable cables as shown in the fi g-
ure. Ideally, use the OPUS 1 or OPUS 3 loudspeaker
cable (optional) with banana plugs or standard loud-
speaker cables with a lead.
Important:
Ensure the poles are connected correctly! A com-
pletely diffuse sound with a weak bass will be pro-
duced if the plus and minus poles are incorrectly con-
nected.
Active variant:
For PIEGA loudspeakers with the Active module op-
tion, please contact your retailer.
Pass the wires fully through the opening
Fully insert the banana plugs up to the stop
9
PIE GA _M an ua l_ un i_ de _R Z.i nd d 2 0 PIEGA_Manual_uni_de_RZ.indd 20 02 .0 8.2 00 7 1 0:3 9:4 1 U hr 02.08.2007 10:39:41 Uhr