Profoon Telecommunicatie TX-230 - Manual (Page 24)

INSTALLATION
POWER SUPPLY:
Open the battery compartment (bottomside) and install 4 pcs 1.5V
AAA batteries. Mind the polarity.
Attention: always disconnect the telephone form the telephone out-
let when batteries are to be installed or replaced.
TELEPHONECORD & HANDSETCORD:
1.
connect the supplied handsetcord between the handset and
base
2. connect the telephonecord to the bottomside of the telephone;
push the connectors till you hear a click
3. plug the telephone plug into your telephone outlet
PABX:
In case the TX-230 will be connected to a PABX, check if the
PABX is suitable for Caller-ID. If not, the TX-230 has to be connec-
ted directly to the public telephone network.
WALL MOUNT:
1.
drill two holes in the wall with a distance of 9 cm and insert
two screws. Let the heads of the screws stick out a few
millimeters of the wall
2. click the wall mount plate to the bottomside of the base-part
3. remove the handsetholder, rotate it 180° and replace it. This
holder will hold the handset when wall mounted
4. hang the unit on the wall and fixate the telephone wire by
means of cable-clips
Once the power adaptor is plugged into a 230V mains outlet or the
batteries have been installed, the telephone is ready for use.
PROGRAMMING
Make sure that during the programming, the telephone must be
connected to your telephoneline.
DISPLAY LANGUAGE:
The several messages can come on the display with different lan-
guages. Follow these instructions to select the required language:
1.
leave the handset on the cradle
2. press and hold the button
3. press and hold the button
4. press , the display shows "NEDERLAND" (or another
language), now release the buttons
5. use buttons and to select another language
6. press to store the selected language
24