Panasonic KX-TD816NZ User Manual
Page 219
6.1
Troubleshooting
Appendix
219
"PS NO CONNECTED" is displayed.
•
The power switch is set to OFF.
Turn it ON. (
Portable Station Button Descriptions)
•
The PS is out of range.
Move closer to the CS.
•
The radio channel is busy or a radio communication
error occurred.
Try again later.
"REGISTER UNIT" is displayed.
•
The PS is not registered in the system.
Consult your dealer.
"NO SERVICE" is displayed.
•
The PS is out of range.
Move closer to the CS.
You cannot store a phone number and
name in the directory.
•
Your entry exceeds the maximum digits or
characters.
•
Do not pause for over 30 seconds while
programming.
The alarm sounds after pressing the
Redial button.
•
A number is not saved in the Call Log.
"
" flashes or beeps tones sound
every 5 seconds during a
conversation.
•
The battery is low.
Charge the batteries fully. (
the DECT Portable Station Battery Charge)
You charged the batteries fully, but
"
" flashes.
Clean the charge contacts and charge again.
It is time to change the batteries. Please purchase new
batteries.
The PS stops working during
operation.
Turn the power switch OFF and ON. Then try again.
(
Before Operating the DECT Portable Station
Button Descriptions)
Re-insert the battery and try again. (
Operating the DECT Portable Station Battery Charge)
Handover does not work.
•
You moved to a busy CS or are out of range.
•
You moved while not having a conversation (e.g.,
while hearing a busy tone).
•
The radio channel is busy or a radio communication
error occurred.
The display does not show a strong
radio signal "
" even though you
are near the CS.
•
Normally, the PS user can make a call even with a
"
" status. In this case, the current linked CS is still
connected even though another CS is closer.
The alarm sounds during a
conversation while receiving a weak
radio signal "
."
•
The radio signal is weak.
Move closer to the CS.
Problem
Remedy