PYLE Audio PL2DNTV7 User Manual

Page 16

Advertising
background image

4. Reconnect the terminal of the battery of procedure.

Notes

● If your vehicle ignition does not come with an ACC position, connect the ignition cables

to a power source that can be turned on and turned off with the ignition key. If you
connect the ignition cable to a power source that receives a constant voltage supply, as
with battery cable, the battery may be overloaded.


● If the fuse blows, first check whether the cables have caused a short circuit or not, then

replace the old fuse with a new one of the same type.


● Do not let unconnected cables or terminals touch the metal on the car of anything else

conducting electricity. Besides, to prevent short circuits, do not remove the caps from
unused terminals or from the ends of the unconnected cables.


● After the monitor unit is installed, please check whether the brake lamps, blinkers,

wipers, etc…on the vehicle can work properly.

.
● Please cover unconnected cables or terminals with rubberized tape or insulators.

Troubleshooting

Problems Possible

Cause

Remedy

No picture and
sound when the
monitor is turned
on

1. Power wire is connected

improperly or fuse is blown.

2. System cable isn’t

connected or contacts
unwell.

1. Check the power wire

and replace the fuse.

2. Check the system cable

or replace a new one.

Blurry picture on
the screen

Interfered by short-distanced
strong interference (e.g.
motorbike, high voltage wire,
transformation station or
aircraft etc…)

The reception of signal will
get better immediately once
leaving the interference
area.

No function on the
remote control (or
operation distance
is shortened)

1. The battery of remote

control has exhausted.

2. Remote control is destroyed.

1. Change a new rating

battery.

2. Contact with the dealer

and then change a new
remote control.

The picture on the
screen is relatively
dark.

The equipment locates at a low
temperature area.

This is the character of LCD
monitor in low temperature,
it will restore to normal
brightness after powering on
the monitor for few minutes.

14

Advertising