PYLE Audio PLDVD7M - Manual (Page 11)

TROUBLE SHOOTING
Symptom and Solution:
When having problem with the unit, please check this list for a
possible solution before asking for service.
Symptom Reason Solution
No Power Connections are bad
Battery is bad
Ignition is OFF Check all cables
Check the battery
Switch the ignition to ON
No picture Connections are bad
Monitor is in incorrect setting Check all RCA connections
Setup Monitor in correct mode
No Sound Connections are bad
Audio output setting is incorrect
Mute is ON, or Volume is 0 Check all audio connections
Setup audio output correctly
Press Mute, or increase
volume
Distorted Picture Disk is dirty or damaged
You are in fast forward or fast
Reverse mode
Clean disk, or change disk
Press PLAY to resume normal
playback
Luminance Uns-
teady,or Picture
with Noise Circuitry Influence
Bad connection
Connect source directly to
monitor
Check all cables
Unable to Play
No disk is loaded
Disk is bad or dirty
Disk is upside down
Parental Lock is on
Menu is active
Insert a disk
Replace the disk or clean it
Insert disc with the label side
facing up
Remove or change parental
settings
Press setup to remove menu
Keys do not
function Power wave or other normal
phenomena( such as static) Switch the unit off and on
again
Remote control
does not work Remote control is too far away
from the DVD, or objects are
blocking its path
Batteries are exhausted
Use the remote control within
7 meters, taking care to point
at it directly or within a 30
degrees angle.
Replace batteries
DVD unable to
play When press
the power on
DVD main board doesn't drive It have to shut down power
system and then re-start again
10