Pioneer DV58AV_KU_EN - Manual (Page 12)

02
12
En
Connecting using the S-Video output
If your TV (or other equipment) has an S-Video input, you can use the
S-Video output on this player instead of the standard (composite)
output for a better quality picture.
• Use an S-Video cable (not supplied) to connect the S-VIDEO
OUT to an S-Video input on your TV (or monitor or AV
receiver).
Line up the small triangle above the jack with the same mark on the
plug before plugging in.
Connecting using the component video
output
You can use the component video output instead of the standard
video out jack to connect this player to your TV (or other equipment).
This should give you the best quality picture from the three types of
video output available.
• Use a component video cable (not supplied) to connect the
COMPONENT VIDEO OUT jacks to a component video input on
your TV, monitor or AV receiver.
Watching 1080i/720p/480p from the component video
outputs
This player can output 1080i/720p/480p from the component video
output. Compared to 480i, 1080i/720p/480p effectively doubles the
scanning rate of the picture, resulting in a very stable, flicker-free
image.
To set up the player for use with a progressive scan or HD (High
Definition) TV, see
Resolution (Max) on page 33. When the player
is set to output progressive scan video, the PRGSVE indicator lights
in the front panel display.
Important
• If you connect a TV that is not compatible with a 1080i/720p/480p
and switch the player to them, you will not be able to see any
picture at all. In this case, switch everything off and reconnect
using the supplied video cable (see Easy connections on
page 11), then switch back to
480i (see Switching the video
output to 480i using the front panel controls on page 12).
Switching the video output to 480i using the front panel
controls
Switch the player to standby then, using the front panel controls,
press
 STANDBY/ON while pressing   to switch the player
back to 480i.
• If the player is connected using HDMI, disconnect the HDMI
cable before resetting the player to 480i output. (If left
connected, the HDMI output resolution will be reset to its
default — see Resetting the output resolution to the default
setting with HDMI connection on page 15.)
TV
To S-Video input
TV
To component video input
DV58AV_KU_EN.book 12 ページ ２００７年８月３０日 木曜日 午後３時２３分