PYLE Audio PLTV65R - Manual (Page 12)

12
OPERATION
Adjusting the loud
In loud mode, use VOLUME /
buttons (7&8) or VOL / buttons(47)
to switch between loud on and off.
When LOUD on, "LOUD" will show
on the display (4).
Directly press LOUD button (52) to
reinforce the bass output. Press it
again to release the function.
Adjusting the equalization
In equalization mode, use VOLUME
/ buttons (7&8) or VOL /
buttons (47) to switch between the
following mode and the
corresponding information appears
on the LCD (4).
FLAT POP JAZZ CLAS
Directly press EQ button (51) to turn
on equalization function and to
select desired audio mode as above.
Mute
Press MUTE button (3) on the front
panelor MUTE button (43) on remote
control to cut down sound output.
Press it again to resume the previous
volume mode.
Setting the clock
Press DISP button (44) to change the
display into clock display. While the
current time is appeared on the LCD (4),
press it again to return to frequency
showing.
Holding down DISP button (44) for
several seconds, and the time for hours
is blinking on the display (4), then press
VOLUME / buttons (7&8) or VOL /
buttons (47) to switch between hours
and minutes. Press TUNING / buttons
(13&14) or TUN/CH / buttons (46) to
adjust the hours or minutes.
Note: When you first press DISP button
(44), the clock will appear on the LCD,
after several seconds, the clock will
disappear and the LCD enter into
frequency showing if you don't operate it.
Then you press DISP button again, the
LCD remains the previous state and the
clock will not appear. You should press
DISP button once again to display the
clock.
Radio operation
Switching to radio mode
Press MODE button (12) on the front
panel or MODE button (42) on the
remote control to select radio mode,
the radio mode appears in the display
together with the memory band and
frequency.
Selecting the frequency band
Press BND button (11) on the front
panel or BAND button (40) on remote
control to select desired band. The
reception band will change in the
following order:
FM1 FM2 FM3 AM1 AM2
Selecting station
During radio mode, press TUNING
button (13) or TUN/CH button on
remote control to increase frequency
or TUNING button (14) or
TUN/CH button on remote control
to decrease frequency by one step of
channel spacing. Hold the button
longer for fast tuning. The frequency
is updated correspondingly on display.
Setting memory
Press preset memory buttons (1~6)
(15)on the front panel or Radio Preset
buttons(1~6) (37) on remote control
to preset stations at radio mode. With
this system, a total of 30 stations can
be stored in the memory of six buttons.
Each band stores up to six preset
stations.
The stations might be FM1, FM2,
FM3, AM1/MW and AM2/LW band.
The operation is as below:
- Store in Memory
Press and hold desired memory
location button for several
seconds. The current listening
station will be stored into the
number button.