Basic connections & initial setup, Connecting, How to do initial setup – Panasonic PV-24DF62 User Manual
Page 10
10
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]
Basic Connections & Initial Setup
For ANT./Cable
Connect the cable from
Antenna/Cable to the VHF/
UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on
your cable box to the VHF/
UHF terminal on the unit
with a RF cable.
VHF/UHF
UNIT
IN from
ANT./CABLE
VHF/UHF
WARNING:
Overtightening "Nut type" RF
coaxial cables may damage
jacks. Finger tighten only.
VHF/UHF
Cable TV
Converter Box
Connecting
Press POWER* on the remote or unit.
• Turn on your cable box and set it to PBS (Public
Broadcast Station) channel in your time zone.
If you use DSS receiver, it must be turned off.
Press CH to start
CHANNEL/CLOCK
AUTO SET operation.
1
3
Press TV on the remote for TV mode.
Press CH to select
English.
OR
Press CH to select
Spanish (Español).
OR
Press VOL+ to select
French (Français).
2
How to do Initial Setup
CHANNEL / CLOCK AUTO SET
CONNECT ANTENNA CABLE
LOCAL PBS CH THEN. . .
AND I F YOU USE A CABLE
BOX, TUNE I T TO YOUR
PLE ASE PRESS CH UP KEY
2 / 6 / 2002 WED 12 : 00PM
DST : ON
AUTO CLOCK SET
COMPLETED
SETT I NG : CH 1 0
END : PRESS CH UP KEY
PLEASE SET CLOCK BY
PRESS I NG ACT I ON KEY
AUTO CLOCK SET
I S I NCOMPLETE
Setup completed
Setup incomplete
If the setup is completed, the
following screen is displayed.
If the following screen is displayed,
set the clock manually. (See
"Manual Clock Set" on next page.)
• If time is not correct... even though
your area observes daylight saving
time and DST is set to ON, do “Time
Zone Adjust” steps on page 13.
IN from
ANT./CABLE
VHF/UHF