Pioneer VSX-AX4AVi-G - Manual (Page 65)

Using other functions 10
65
En
Reducing the level of an analog signal
The input attenuator lowers the input level of an analog
signal when it’s too strong. You can use this if you find
the that the
OVER indicator is lights often, or you can
hear distortion in the sound.
1
• Press ANALOG ATT to switch the input attenuator
on or off.
Watching video and audio sources
independently
You can listen to a sound source and select a different
video source on your TV.
• While listening to a source, press VIDEO SEL ( VIDEO
SELECT ) to select the video source you want to watch.
Press repeatedly to cycle through the possible video
sources. You can select
DVD , TV , SAT , DVR1 , DVR2 ,
VIDEO1 , VIDEO2 or OFF (no video signal). 2
Using the sleep timer
The sleep timer switches the receiver into standby after a
specified amount of time so you can fall asleep without
worrying about the receiver being left on all night. Use
the remote control to set the sleep timer.
• Press SLEEP repeatedly to set the sleep time.
• You can check the remaining sleep time at any time
by pressing SLEEP once. Pressing repeatedly will
cycle through the sleep options again. 3
Dimming the display
You can choose between four brightness levels for the
front panel display. Note that when selecting sources,
the display automatically brightens for a few seconds.
• Press DIMMER repeatedly to change the brightness
of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system,
but it is possible to switch the impedance setting if you
plan to use speakers with a 6
Ω impedance rating. Use
the front panel controls to do this.
• With the receiver in standby, press STANDBY/
ON while holding down the SPEAKERS button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your speakers are
rated at 6 Ω .
• SP 8 OHM – Use this setting if your speakers are
rated at 8 Ω or more.
Checking your system settings
Use the status display screen to check your current
settings for features such as surround back channel
processing and your current MCACC preset.
1 Press STATUS to check the system settings.
These appear on both the OSD and the front panel
display.
4
Note
1. The attenuator isn’t available with digital sources, or when using the Stream Direct modes.
2. Note that this feature will not work with video sources assigned to either of the HDMI video inputs.
3. You can also switch off the sleep timer simply by switching off the receiver.
SLEEP
SR+
ANALOG
ATT VIDEO
SEL
DIMMER
CLASS D.ACCESS
SLEEP
SR+
ANALOG
ATT VIDEO
SEL
DIMMER
CLASS D.ACCESS
SLEEP
SR+
ANALOG
ATT VIDEO
SEL
DIMMER
CLASS D.ACCESS
Off
30 min 60 min
90 min
4. If the Pure Direct mode is switched on, some settings above will show OFF , even though they are on.
SLEEP
SR+
ANALOG
ATT VIDEO
SEL
DIMMER
CLASS D.ACCESS
SHIFT MCACC S.DIRECT
MULTI OPE
SIGNAL SEL SBch STEREO
AUDIO SUBTITLE
ADV. SURR STANDARD
PHASE
THX
HDD
CH CH
DVD
DISP
STATUS
STATUS
96kHz STEREO
Signal Select
: AUTO
SBch Processin : OFF
Video Select
: OFF
MCACC Position : M1
Room2/REC SEL : SOURCE
Room3
: SOURCE
VSX_AX4AVi_G.book.fm 65 ページ ２００５年７月６日 水曜日 午後４時１２分