PYLE Audio PLCD82MP - Manual (Page 4)

3 8
INSTALLATION
INSTALLATION WAY
IT IS AN ANTI-THEFT INSTALLATION WAY. THE CHASSIS WEAR A METAL
SLIDING HOUSING. PLEASE HAVE THE WIRING CONNECTION OF THE
POWER SUPPLY, SPEAKERS AND ANTENNA AS FOR THE REQUIREMENT
OF THE MANUAL, THEN INSTALL THE METAL SLIDING HOUSING INTO THE
CAR ACCORDING TO THE DIAGRAM.
TO BOOST UP THE CAPABILITY OF
ANTI-JAMMING, PLEASE FIX THE
METAL STRAP ON THE METAL
CONNECTED TO THE BOTTOM
BRACKET OF THE CAR.
METAL STRAP
DASH BOARD
SLIDING METAL HOUSING
TO DRAW THE CHASSIS OUT OF THE
SLIDING METAL HOUSING, INSERT
THE LEFT AND RIGHT KEY PLATES
INTO THE RIGHT POSITION OF THE
2 SIDES OF CHASSIS.
FRONT PANEL
PLASTIC TRIM OUT
UNIT CHASSIS
SELECT THE PROPER FIXER
FOR FIXING THE SLIDING
METAL HOUSING.
NOTE
REMOVE THE SLIDING
METAL HOUSING AWAY
REMOVE AWAY 2 SCREWS FOR PROTECT
THE DECK BEFORE OPERATING IT.
TO INSTALL THE FRONT PANEL
BACK INTO THE UNIT CHASSIS,
FIRSTLY INSTALL THE RIGHT
SIDE IF IT BACK INTO THE RIGHT
POSITION, THEN PUSH THE LEFT
SIDE BACK TO THE UNIT CHASSIS
TILL OK.
RESET BUTTON
PRESS RESET BUTTON TO RESUME
THE DISTORTED PROGRAM WHEN
THE LCD DISPLAY IMPROPERLY AND
SOME BUTTONS ARE INVALID.
OPEN BUTTON
TO INSERT DISC INTO COMPARTMENT OR EJECT DISC OUT
OF THE COMPARTMENT OR TAKE THE FRONT PANEL AWAY
THE UNIT CHASSIS, PRESS THE OPEN BUTTON TO FLIP
DOWN THE FRONT PANEL.
AFTER FLIPPING DOWN THE
FRONT PANEL, DRAW THE
FRONT PANEL OUT OF THE
CLIP.
REMOTE CONTROL BASICS BATTERY REPLACEMENT:
1.Remove the battery holder as the direction indicated by the arrow.
2.Replace the battery Set a new battery property with (+)side up.
3.Insert the battery holder. Push in the holder to the original position.
NOTE ON BATTERIES:
Old batteries must immediately be removed and disposed.
BATTERY INFORMATION:
Designated Battery: UM-4"AAA"/R05
Battery Life: 6 months with normal use (in normal room temperatur)
CAUTION:
Improper use of batteries may cause overheating, explosion or ignition. Resulting in
jury or fire .Battery leakage may cause damage to the unit.
Do not disassemble or short the batteries. Do not throw the batteries into the fire.
To avoid the risk of accident, keep the batteries out of reach of children.
1. LOCAL/DISTANCE BUTTON
If you find the receiving signal is weak and there is the
word LOC displayed on LCD when you tune for distance
station, firstly press the button to disappear the word
LOC on LCD, then tune again for the distance station.
If you find the interference to the receiving signal is very
strong and there is not the word LOC displayed on LCD
when you tune for local station, firstly press the button to
display the word LOC on LCD, then tune again for the local
station.
2. LOUDNESS BUTTON
Press it to enhance the BASS sound effect immediately
when it is in BASE mode.