Panasonic CR-SRT100 - Manual (Page 49)

CR-SRF100/CR-SRT100
48
3. RECEIVER ERROR
If communication between the receiver and CDU stops for approximately 6-9 seconds, then a “RECEIVER
ERROR” message is displayed).
Action: Check the electrical harness between the CDU and the receiver.
4. NO SUBSCRIPTION
If the CDU determines that there is no subscription to the Sirius service, then the message “CALL 888-
539-SIRIUS TO SUBSCRIBE” will scroll twice on the display. Pressing any key will then cause the Sirius
ID to be displayed. Further key presses alternate between the Call Sirius message and the Sirius ID.
Action: Subscribe according to the instructions earlier in this manual.
5. ANTENNA ERROR
If the receiver detects an electrical problem with the antenna circuit, the “ANTENNA ERROR” message will
be displayed on the second line.
Action: Verify the electrical connection between the receiver and both antenna wires.
6. ACQUIRING SIGNAL
If there is a lack of both a satellite and terrestrial signal, the “ACQUIRING SIGNAL” message will be dis-
played on the second line.
Action: Make sure the antenna is not obstructed by any large objects (bridges, garages, tall buildings, etc.)
17233_SGould 08/15/02 14:46 Page 48