Paradyne 3800 - Manual (Page 47)

COMSPHERE 3800 Series Modems – Model 3830
4-12 November 1996 3830-A2-GB91-20
Table 4-2
(6 of 22)
Model 3830 AT Commands
X n

Extended Result Code, Dial Tone Detect, and Busy Tone Detect
The X n command sets three configuration options simultaneously:
Ext Dial Tone Busy Tone
Result Code Detect Detect
X0 Disable Disable Disable
X1 Enable Disable Disable
X2 Enable Enable Disable
X3 Enable Disable Enable
X4 Enable Enable Enable
X5 Add/EC Enable Enable
X6 Add/V42,MNP Enable Enable
X7 Use DTE Rate Enable Enable
EXTENDED RESULT CODE
Informational messages such as VF (line) connect rate and Error Control
are displayed with the result codes.
Disable. Displays basic result codes: OK, CONNECT, RING, NO
CARRIER, and ERROR.
Enable. Displays basic result codes in addition to the CONNECT rate
message (for example, CONNECT 14400).
Add/EC. If error control is negotiated, attaches the /EC suffix to the
CONNECT rate message.
Add/V42,MNP. Attaches the V42b, V42, MNP5, MNP4, MNP3, MNP2, or
NoEC suffixes to the CONNECT rate message.
Use DTE Rate. Displays DTE data rate instead of line CONNECT rate
message.
DIAL TONE DETECT
Sets the modem for dial tone detection (enable) or blind dialing (disable).
Disable. Sets the modem for blind dialing.
Enable. Sets the modem for dial tone detect.