Paradyne 3800 - Manual (Page 62)

4. AT Command Set and S-Registers
4-27 3830-A2-GB91-20 November 1996
Table 4-2
(21 of 22)
Model 3830 AT Commands
\Tn

No Data Disconnect Timer
Forces the modem to disconnect if no data is transmitted or received
within a specified amount of time.
\T0 Disable.
\Tn Where
n is a value from 1 to 255 in 1-minute increments.
\ Xn

XON/XOFF Passthrough Flow Control
The way this configuration option functions depends on how the modem
is configured for flow control.
When the modem is configured for XON/XOFF flow control (see \Q n,
Flow Control of DTE), this configuration option determines if flow control
characters received from the local DTE will be passed on to the remote
modem.
If configured for modem-to-modem flow control (see \G – Modem to
Modem Flow Control), this configuration option determines if flow control
characters received from the line will be passed on to the DTE.
\ X0 Disable.
\ X1 Enable.
% An

Error Control Fallback Character
This configuration option allows you to enter the ASCII value of the error
control fallback character. This provides the remote modem with the
ability to end the error control link negotiating (handshaking) sequence by
sending this character. The modems will connect in Buffer mode (no error
control). Online changes do not take effect until a disconnect occurs.
%An Where n is an ASCII value from 0 to 127. Factory default is 013
(ASCII carriage return).
%Cn

MNP5 Data Compression
Determines if the modem uses MNP Class 5 data compression. It can be
set independently of V.42 bis data compression. Online changes do not
take effect until a disconnect occurs.
%C0 Disable.
%C1 Enable.