Powermatic 511 - Manual (Page 32)

32
Short Panel Fence (Optional Accessory)
The Short Panel Fence is designed as an aid in cutting short panels by bringing the panel up to waist
height. The Fence fits on both the left and right sides of the panel saw which gives support when
cutting. Figure 23 shows the components of the Short Panel Fence.
Part No.
Description Size Qty.
2721005....... Short Panel Fence Shelf Assembly
3064729....... Short Panel Fence Bracket R.H............................................. ....................................1
3064730....... Short Panel Fence Bracket L.H. ............................................ ....................................1
3064731....... Short Panel Fence Midway Bracket ....................................... ....................................2
3596135....... Side Plate (Shelf) .................................................................. ....................................2
3745051....... Spacer .................................................................................. .................................. 10
6516002....... Hex Lock Nut ........................................................................ 3/8-16........................ 10
6687015....... Tape Scale............................................................................ ....................................2
6716035....... Hex Head Cap Screw............................................................ 3/8-16 x 1-3/4 Lg ....... 10
6746023....... Hex Washer Head Screw (Self Tapping) ............................... 1/4-20 x 5/8 Lg .......... 10
6861301....... Flat Washer .......................................................................... 3/8............................. 10
Figure 23
Installation of Short Panel Fence
Step 1:
a. On the left side of the panel saw,
temporarily place the fence shelf on top of
the horizontal cross member of the panel
saw frame which is approximately 30" from
the floor. See Figure 24. This will space
the left hand fence bracket the correct
distance off the horizontal cross member.
b. Place the left hand fence bracket (bracket
with scale reading right to left) on top of
the fence shelf (with the scale side of the
bracket facing out).
c. Align the left side of the bracket with left
end of the horizontal cross member.
(Note: There should be approximately a
1/2" gap between the bracket and the right
end of the horizontal cross member, as
shown in Figure 25).
Figure 24
Figure 25