Paradyne OpenLane SLM 5.5 - Manual (Page 97)

A. OLCmd Reference
7800-A2-GB32-00 January 2002 A-27
OLCmd sync
The sync command synchronizes a specified device and the database. If the
device is not in the database, it is added.
Format:
OLCmd sync [ [ -v ] [ -c community-string ] [ -w community-string ]
[ [ -i ftp_user ] [ -p ftp_passwd ] ] [ -g groupid ] [ -s ] [ -f ] [ -d domain ]
[ -I minutes ] [ -k days ] [ -r days ] [ -h ] [ -A ] [ -S ] [ -E ] [ -O ]
[ ip_address | hostname ] ]
Where:
ip_address Is the address of the device to be synchronized.
hostname Is the host name of the device to be synchronized.
-v Specifies that debugging information should be
returned.
-c community-string Sets the name of the read community string for the
device.
-w community-string Sets the name of the write community string for the
device.
-i ftp_user Specifies the user ID for the FTP session used to
collect performance statistics.
-p ftp_passwd Specifies the password for an FTP session initiated by
ftp_user.
-g groupid Specifies the group ID for the device.
-s Enables SCM polling (for DSLAM devices only).
-f Enables user history polling (for FrameSaver devices
only).
-d domain Specifies the domain where the poller/reader resides.
-I minutes Specifies the number of minutes between polls. This
should be less than 1440 (24 hours) to ensure that no
data is lost.
-k days Specifies the number of days’ worth of hourly report
data that should be maintained for the device.
-r days Specifies the number of days’ worth of quarter-hourly
report data that should be maintained for the device.
-h Specifies that the device is a head-end FrameSaver.
-A Causes the parameters to be saved without
synchronizing the device.
-S Requests that circuits and endpoints be discovered in
the course of synchronizing the device.