Pioneer PDR-509 - Manual (Page 36)

36
Additional Information
Understanding Display Messages
Below is a list of messages you’ll see during normal operation of the PDR–509 together with a brief explanation of what they
mean. If you need more information, turn to the page indicated.
Message
OPEN
CLOSE
SET UP
TOC READ
1-SYNC
AL-SYNC
CAN NOT SYNC
MONI INPUT
(CD, MD, DAT, DCC,DVD)
PMA REC
TRACK ?
SKIP SET?
SKIP CLEAR?
LAST ?
ALL ?
TOC ?
** - [LAST] ?
(** is a number)
ALL DISC ERASE?
CD-R CD-RW
Description
The disc tray is open.
The disc tray is closing.
The unit is setting up for recording. Wait for the message to disappear.
The recorder is reading the disc’s TOC (Table of Contents). Wait for the
message to disappear.
The unit is in 1-track automatic digital recording mode. Recording starts when
the recorder detects the digital source input signal.
The unit is in all-track automatic digital recording mode. Recording starts when
the recorder detects the digital source input signal.
This display appears when the DIGITAL SYNCHRO button is pressed if the INPUT
SELECTOR is set for an analog source, or in digital mode if the source selected
is not recognized as CD , MD , DAT , or DCC .
The recorder is monitoring the input selected with the input selector. The unit
displays the source it is monitoring (
CD , MD , DAT , DCC , or DVD ).
The recorder is writing TOC data to the disc’s PMA (Program Memory Area).
Never turn off the power while this display is showing.
The recorder is waiting for you to enter a track in program play mode. Select a
track using the numeric buttons,
4 and ¢ (track skip) buttons, or jog dial.
Confirm that you want to set a skip ID by pressing the SKIP ID SET button.
Confirm that you want to set a skip ID by pressing the SKIP ID CLEAR button.
Confirm that you want to erase the last track of a CD – RW disc by pressing 8
(pause).
Confirm that you want to erase all tracks on a CD – RW disc by pressing 8
(pause).
Confirm that you want to erase the TOC of a finalized CD – RW disc to return it to
a non-finalized state. After doing this, you can record more material on the disc.
Confirm that you want to erase tracks recorded on a CD – RW disc .
Confirm that you want to re-initialize the CD – RW disc by pressing 8 (pause).
This display is for in-store demonstration purposes. The demonstration stops
when any key or control is operated. If no key or control is pressed for about
three minutes after the demonstration was stopped, it will start again.
To start the demonstration mode, switch on the power with a disc loaded and
press
1 as soon as the display reads 01 00:00.
To cancel the demonstration mode, switch on the power with a disc loaded
and press
¡ as soon as the display reads 01 00:00.
Reference
p.15
p.15
p.20
p.21
p.32
p.26
p.28
p.29
p.34
pp.34–35
p.35
p.34
p.35