Pioneer DEH-P4800MP - Manual (Page 4)

4
EN
G
L
IS
H
Connecting the Units
Note
Depending on the kind of vehicle, the function of 3*
and 5* may be different. In this case, be sure to
connect 2* to 5* and 4* to 3*.
Connect leads of the same
color to each other.
System remote control
Cap (1*)
When not using this
terminal, do not remove
the cap.
Yellow (3*)
Back-up (or accessory)
Yellow (2*)
To terminal always supplied with
power regardless of ignition switch
position.
Red (5*)
Accessory (or back-up)
Red (4*)
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
Black (ground)
To vehicle (metal) body.
ISO connector
Note
In some vehicles, the ISO connector may be
divided into two. In this case, be sure to
connect to both connectors.
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and 7*
when Pin 5 is an antenna control type. In another
type of vehicle, never connect 6* and 7*.
Speaker leads
White:
Front left +
White/black: Front left -
Gray: Front right +
Gray/black: Front right -
Green: Rear left + or Subwoofer +
Green/black: Rear left - or Subwoofer -
Violet: Rear right + or Subwoofer +
Violet/black: Rear right - or Subwoofer -
Blue/white (6*)
Blue/white (7*)
To Auto-antenna relay control
terminal (max. 300 mA 12 V DC).
Power amp
(sold separately)
Jack for Wired Remote Control
Please see the Instruction Manual
for the Wired Remote Control (sold
separately).
Subwoofer output or
Rear output
Antenna jack
Fuse (10 A)
Connecting cords with RCA pin
plugs (sold separately)
This product
Left
Subwoofer or
Rear speaker
Blue/white
To system control terminal of the
power amp (max. 300 mA 12 V DC).
Right
Perform these connections when
using the optional amplifier.
Power amp
(sold separately)
IP-BUS cable
Mult-CD player
(sold separately)
IP-BUS input
(Blue)
Front output
AUX jack (3.5 ø)
Subwoofer or
Rear speaker
Front speaker Front speaker
Note
Use a stereo mini plug
cable to connect with
auxiliary equipment.
The pin position of the ISO connector will differ
depends on the type of vehicle. Connect 6* and 7*
when Pin 5 is an antenna control type. In another
type of vehicle, never connect 6* and 7*.
Note
Change the initial setting of this unit (refer
to the Operation Manual). The subwoofer
output of this unit is monaural.
Yellow/black
If you use a cellular telephone, connect it via
the Audio Mute lead on the cellular telephone.
If not, keep the Audio Mute lead free of any
connections.
MAN-DEH-P4800MP-GB.fm Page 4 Thursday, September 29, 2005 11:55 AM