Pioneer PRS-D1000M - Manual (Page 8)

7
Connecting the Unit
Connecting the Power Terminal
• Always use the special red battery and ground
wire ([RD-223] and [RD-222]), which are sold
separately. Connect the battery wire directly to
the car battery positive terminal (+) and the
ground wire to the car body. There is the risk of a
fuse burning out if only one of these is connected.
1. Pass the battery wire from the
engine compartment to the interior
of the vehicle.
• After making all other connections to the
amplifier, connect the battery wire terminal
of the amplifier to the positive (+) terminal of
the battery.
[RD-223]
[RD-222]
2. Twist the battery wire, ground wire
and system remote control wire.
3. Attach lugs to wire ends. Lugs not
supplied.
• Use pliers, etc., to crimp lugs to wires.
4. Connect the wires to the terminal.
• Fix the wires securely with the terminal
screws.
WARNING
Failure to securely fasten the battery wire to the ter-
minal using the terminal screws could cause the ter-
minal area to overheat and could result in damage
and injury including minor burns.
GND terminal
Power terminal
Battery wire
System remote
control terminal
System remote
control wire
Ground wire
Twist
Battery wire
Ground wire
Lug
Lug
Fuse (30 A)
Engine
compart-
ment
Interior of
the vehicle
Drill a 14 mm
(1/2 inch) hole
into the vehicle
body.
Insert the O-ring rubber
grommet into the vehicle
body.
Positive terminal
Fuse (30 A)
Fuse (30 A)
Engine
compart-
ment
Interior of
the vehicle
Drill an 8 mm
(3/8 inch) hole
into the vehicle
body.
Insert the O-ring rubber
grommet into the vehicle
body.
Positive terminal