PSB Speakers PSB-1688LF M1 - Manual (Page 61)

Chapter 4 Award BIOS Setup
Page: 4-14 PSB-1688LF USER
′
S MANUAL
5. DRAM CAS Latency
When synchronous DRAM is installed, the number of clock cycles of
CAS latency depends on the DRAM timing.
6. Bank Interleave
7. Precharge to Active (Trp)
8. Active to Precharge (Tras)
This item controls the number of DRAM clocks for TRAS.
9. Active to CMD (Trcd)
10. DRAM Command Rate
This item set the DRAM command rate.
AGP & P2P BRIDGE CONTROL:
The options for these items are found in its sub menu. By pressing the
<ENTER> key, you are prompt to enter the sub menu of the detailed options
as shown below:
Phoenix – Award CMOS Setup Utility
AGP & P2P Bridge Control
Item Help
AGP Aperture Size
AGP Driving Control
X AGP Driving Value
AGP Fast Write
AGP Master 1 WS Write
AGP Master 1 WS Read
[64M]
[Audo]
DA
[Disabled]
[Disabled]
[Disabled]
Menu Level ►
↑↓→←:Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
Descriptions on each item above are as follows:
1. AGP Aperture Size
This field determines the effective size of the Graphic Aperture used
for a particular GMCH configuration. It can be updated by the
GMCH-specific BIOS configuration sequence before the PCI standard
bus enumeration sequence takes place. If it is not updated then a
default value will select an aperture of maximum size.