Pioneer MILESTONE 12 - Manual (Page 127)

127
Menu Mode [Applicable only when a PDA-5003/PDA-5004 is installed]
9) Signal Format Setting
This display automatically identifies PC signals and video signals such as from a DVD player by the frequency of the
input signal. The panel is equipped with a function for identifying the resolution of a PC signal.
Factory setting: AUTO
1 Select ‘SETUP’.
2 Place the cursor over ‘SIGNAL FORMAT’ then press the
[SET] button.
3 Press the [2/3] buttons to change the setting.
Each time a [ 2/3] button is pressed, the signal format
changes as shown below.
• AUTO ........ It is distinguished as in “5.1.3 List of
Input Correspondence Signals 1) Input
correspondence signals personal
computer signals” (pg. 80 to 82)
• Others ....... Selectable resolutions are displayed
Note
The display method and selectable screen size differs for each setting. In order to obtain a proper reproduction
method and screen size, check the signal format setting when the signal is input. Change the setting as necessary.
M E N U I N P U T 1
ENTER SET EXIT MENU
S C R E E N S E T U P O P T I O N
: D I S A B L E
: M I D D L E
C O L O R T E M P. : M I D D L E
AU TO P OW E R O F F
D N R
: L OW
: O N M P E G N R
C T I
: O F F
: R G B P U R E C I N E M A
C O L O R D E C O D I N G
: AU TO C O L O R S Y S T E M
S I G N A L F O R M AT
P I C T U R E
Screen 2
:
S I G N A L F O R M AT
A U T O
SET SET EXIT MENU
Screen 3
3 AUTO
Others 2
2
3