Pioneer MILESTONE 12 - Manual (Page 154)

154
Integrator Mode
10) SIDE MASK Setting
This mode is for adjusting the brightness of the no-image section around the screen when the screen size is ‘4:3’ etc.
When performing adjustments, pay attention to the brightness balance between the displayed signal and that of the
adjacent sets.
Factory setting: R. LEVEL, G. LEVEL, B. LEVEL ...... 80
AUTO SIDE MASK ......................... OFF
1 Enter the integrator mode.
(Refer to section 5.4.1, “About the Integrator Mode” (pg. 142).)
2 Select ‘OPTION’.
3 Place the cursor on ‘SIDE MASK’ then press the [SET]
button.
4 Place the cursor on a level (R. LEVEL, G. LEVEL, B. LEVEL)
then adjust the setting using the [ 2/3] buttons.
<Adjustable Range>
Each item: 0 to 255 (initial value: 80)
5 Change the setting by pressing the 2/3 buttons to move
the cursor to the ‘AUTO SIDE MASK’.
Each time a 2/3 button is pressed, the setting changes
as shown below.
ON ....... To reduce burning when a black band appears at
both edges of a 4:3 image displayed on a 16:9
screen, a preset side mask is displayed.
OFF ..... It does not operate.
Note
• It is only effective during one screen display.
• It is only effective during INPUT2 and INPUT5 color signal.
• Compatible signals: 1080i, 720p, 1080p
• It takes about five seconds until display starts. If it is a dark image, it may take even longer.
• As the black band on a 16/9 screen disappears, the preset side mask also disappears.
• This function does not operate for patterned or for colored bands.
I N T E G R AT O R I N P U T 1
ENTER
S C R E E N S E T U P O P T I O N P I C T U R E
SET EXIT MENU
P R O G R A M T I M E R
S C R E E N M A S K
S I D E M A S K
V I D E O WA L L
B A U D R A T E
I D N O . S E T
:
:
:
G R E E N
0 1 H
3 8 4 0 0 B P S
Screen 3
S I D E M A S K
8 0
8 0
8 0
R . L E V E L
G . L E V E L
B . L E V E L
D E FA U LT
R E T U R N
:
:
:
A U T O S I D E M A S K O F F :
SET EXIT MENU
Screen 4
Screen 5
S I D E M A S K
8 0
8 0
8 0 R . L E V E L
G . L E V E L
B . L E V E L
D E FA U LT
R E T U R N
:
:
:
A U T O S I D E M A S K O F F :
SET EXIT MENU
3 ON
OFF 2