Epson Stylus Pro 7000 - Manual (Page 46)

2-12
2-12 | Handling Paper
Turning Off Trim Lines
Trim lines are printed on the right edge of your images or pages (if you’re
using Auto Cut) or on the right and bottom edge (if you’re not using Auto
Cut). You can turn off this feature if you don’t want to have trim lines
printed. Follow these steps:
1. Press the SelecType button. PRINTER SETTING MENU appears on
the display.
2. Press the Item button until PAGE LINE=ON appears on the display.
3. Press the + button. PAGE LINE=OFF appears on the display.
4. Press the Enter button to save the new setting.
5. Press the SelecType button to exit the Printer Setting menu.
You can also turn off trim lines through your print options. See Chapter 3 or
4 (or the RIP Station 5100 User Guide) for more information.
Setting Default Roll Paper Margins
The default margins for roll paper are .12 inch or 3 mm (left and right) and
.59 inch or 15 mm (top and bottom). You can set all margins to 3 mm
or 15 mm. However, print quality may be affected near the cut edges if you
change the top and bottom margins to 3 mm.
Follow these steps change the margins:
1. Press the SelecType button. PRINTER SETTING MENU appears on
the display.
2. Press the Item button repeatedly until ROLL MARG=T/B15MM*
appears on the display. This is the default setting.
• Press the + button once to set all margins to 3 mm.
ROLL MARG=3MM appears on the display.
• Press the + button again to set all margins to 15 mm.
ROLL MARG=15MM appears on the display.
You can use the + or – button to cycle through all three settings.