Pioneer DEH-4000UB - Manual (Page 22)

3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
LOW (low)
—MID (mid)—HIGH (high)—OFF
(off)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Using subwoofer output
This unit is equipped with a subwoofer output
which can be turned on or off.
Also, phase can be selected between normal
and reverse.
1 Use MULTI-CONTROL to select
SW SETTING 1.
2 Press MULTI-CONTROL to display the
setting mode.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
NORMAL (normal phase)
—REV (reverse
phase)
—OFF (subwoofer off)
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
! When the subwoofer output is on, you can
select SW SETTING 2.
1 Use MULTI-CONTROL to select
SW SETTING 2.
2 Press MULTI-CONTROL to display the
setting mode.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL repeatedly to switch
the segment in the following order:
Cut off frequency
—Level
4 Turn MULTI-CONTROL to adjust the se-
lected segement.
Cut off frequency
50HZ
—63HZ—80HZ—100HZ—125HZ
Level
+6 to
–24 is displayed as the level is increased
or decreased.
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Use MULTI-CONTROL to select
HIGH PASS FILTER.
2 Press MULTI-CONTROL to display the
setting mode.
3 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
OFF
—50HZ—63HZ—80HZ—100HZ—125HZ
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Boosting the bass
Bass boost function boosts the bass level of
sound.
1 Use MULTI-CONTROL to select
BASS BOOST.
2 Press MULTI-CONTROL to display the
setting mode.
3 Turn MULTI-CONTROL to adjust the
level.
0 to +6 is displayed as the level is increased or
decreased.
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Audio Adjustments
En
22
Section
03