Pioneer DEH-4000UB - Manual (Page 25)

3 Turn MULTI-CONTROL to select the FM
tuning step.
Turning
MULTI-CONTROL will switch the FM
tuning step between 50 kHz and 100 kHz. The
selected FM tuning step will appear in the dis-
play.
# You can also perform the same operations by
pushing
MULTI-CONTROL up or down.
Note
The tuning step remains at 50 kHz during manual
tuning.
Switching Auto PI Seek
The unit can automatically search for a differ-
ent station with the same programming, even
during preset recall.
1 Use MULTI-CONTROL to select AUTO PI.
2 Press MULTI-CONTROL to turn Auto PI
seek on.
# To turn Auto PI seek off, press
MULTI-CONTROL again.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Use MULTI-CONTROL to select AUX.
2 Press MULTI-CONTROL to turn AUX on.
# To turn AUX off, press MULTI-CONTROL
again.
Setting the rear output and
subwoofer controller
This unit
’s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
REAR SP :FULL/
PREOUT :REAR) or subwoofer
(
REAR SP :SUB W/PREOUT :SUB W) connec-
tion. If you switch the rear output setting to
REAR SP :SUB W, you can connect a rear
speaker lead directly to a subwoofer without
using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
REAR SP :FULL). When rear
output is connected to full range speakers
(when
REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
’s (low pass filter,
phase) built-in PREOUT :SUB W or the auxili-
ary PREOUT :REAR.
1 Use MULTI-CONTROL to select
SW CONTROL.
2 Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3 Press MULTI-CONTROL to select the seg-
ment you wish to set.
Press
MULTI-CONTROL repeatedly to switch
the segment in the following order:
REAR SP (rear speaker setting)
—PREOUT
(RCA output setting)
4 Use MULTI-CONTROL to select the de-
sired setting.
Turn to change the setting.
When
REAR SP (rear speaker setting) is se-
lected.
REAR SP :SUB W (subwoofer)
—
REAR SP :FULL (full-range speaker)
When
PREOUT (RCA output setting) is se-
lected.
PREOUT :SUB W (subwoofer)
—
PREOUT :REAR (full-range speaker)
# When no subwoofer is connected to the rear
output, select
REAR SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer
REAR SP :SUB W.
Initial Settings
En
25
English
Section
04