Panasonic PT-AX200U - Manual (Page 21)

E
NGLISH - 21
Basic O
p
eration
Projecting an image
1. Switch on the connected devices.
Press the play button of the required device.
2. Press the INPUT SELECT button to select the
required input method if needed. See “Switching
the input signal” on page 26.
The image will be projected on the screen.
1. Press the ASPECT button to select the required
aspect mode. See “Switching the aspect ratio” on
page 23.
2. Adjust the projected image with the lens shift
levers. See “Lens shift and positioning” on
page 16.
3. Adjust the angle of the projector.
Screw down the front leg adjusters and adjust the
angle vertically.
See “Front leg adjusters and throwing angle” on
page 15.
4. Adjust the focus and the projected image size.
Turn the focus ring and zoom ring to adjust.
You can confirm the result with TEST PATTERN.
See “TEST PATTERN” on page 39.
Selecting the input signal
NOTE:
• AUTO SEARCH is ON as default and the signal from
the connected devices is detected automatically. See
“AUTO SEARCH” on page 38.
Positioning the image
NOTE:
• Do not touch the air exhaust port as this may cause
burns or injury.
• If keystone distortion occurs, see “KEYSTONE” on
page 36.
• If you adjust the focus, you may need to adjust the size
of the image again.
Focus ring
Zoom ring