Planet Technology VC-412 - Manual (Page 37)

VC-412 User’s Manual
33
VDSL port Enable
Speed Mode = Auto Speed
X To exit ICD command prompt
VLAN Command
V Show the current VLAN settings
VO Set VLAN to ON
*1
VF Set VLAN to OFF
VG <group>-<port>, ..., <port> Select the <port(s)> to belong to <group>
The available VLAN group number is from 1 to 16. Issue this
VG command will automatically switch the VLAN mode to
USER DEFINED.
Example: “VG 2-1,2,3,B” will create VLAN group 2 with
member ports:1,2,3 and B.
VG <group> Empty VLAN Ports group
VDSL Command
LT <port>-<speed> Set VDSL <port> to <speed> on local(LT) end
There are six speed levels to select from when
setting VDSL port speed. A, B, C, D is for
VC-101S firmware version R4.5. P is for
firmware version R2 and Q is for firmware
version R4.
A: Downstream 4 Mbps/Upstream 1 Mbps (R4.5)
B: Downstream 5 Mbps/Upstream 5 Mbps (R4.5)
C: Downstream 11 Mbps/Upstream 11 Mbps (R4.5)
D: Downstream 15 Mbps/Upstream 17 Mbps (R4.5)
P: Downstream 11 Mbps/Upstream 11 Mbps (R2)
Q: Downstream 15 Mbps/Upstream 17 Mbps (R4)
Example: “LT 2-B” will configure local port 2’s speed to
symmetric 5Mbps
RT <port>-<speed> Set VDSL <port> to <speed> on remote(RT) end
LR <port>-<speed> Set VDSL <port> to preset <speed>.
Please then issue S command if you want to save this
settings.
LR <port>- Set VDSL <port> to auto-speed
SR <port> Save data on remote side of VDSL <port>
Port Command
PC Show all counters for all ports
PC <port> Show all counters for <port>
C Clear all counters for all ports
C <port> Clear all counters for <port>