Pioneer SUPER TUNER III D DEH-P8850MP - Manual (Page 48)

Black plate (48,1)
Fader (balance adjustment) —Position (posi-
tion selector)
—TA Mode (time alignment set-
ting)
—Time Alignment (time alignment
adjusting)
—Loudness (loudness)—Powerful
(graphic equalizer adjustment) —FREQ. (16-
band graphic equalizer adjustment) —
Subwoofer1 (subwoofer on/off) —
Subwoofer2 (subwoofer cut-off frequency) —
Subwoofer3 (subwoofer slope) —Front HPF
(front high pass filter slope)
—
Front HPF FREQ. (front high pass filter cut-off
frequency)
—Rear HPF (rear high pass filter
slope)
—Rear HPF FREQ. (rear high pass filter
cut-off frequency)
—BBE (BBE)—COMP/BMX
(Compression and BMX)
—Auto EQ (auto-
equalizer on/off)
—SLA (source level adjust-
ment)
—AUI sound level (auditory user inter-
face)
# When selecting OFF in TA Mode, you cannot
switch to
Time Alignment.
# You can select Subwoofer2 and
Subwoofer3 only when subwoofer output is
turned on in
Subwoofer1.
# When tuner, television or AUX is selected as a
source, you cannot select
COMP/BMX.
# When selecting the FM tuner as the source,
you cannot switch to
SLA.
# To return to the display of each source, press
BAND.
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.
Using the position selector
One way to assure a more natural sound is to
clearly position the stereo image, putting you
right in the center of the sound field. The posi-
tion selector function lets you automatically
adjust the speakers
’ output levels and inserts
a delay time to match the number and posi-
tion of occupied seats.
1 Use MULTI-CONTROL to select Position.
Position appears in the display.
2 Push MULTI-CONTROL left, right, up or
down to select a listening position.
Direction Display Position
Left Front Left Front seat left
Right Front Right Front seat right
Up Front Front seats
Down All All seats
# To cancel the selected listening position, push
MULTI-CONTROL in the same direction again.
Using balance adjustment
You can change the fader/balance setting so
that it can provide you an ideal listening envir-
onment in all occupied seats.
1 Use MULTI-CONTROL to select Fader.
Fader appears in the display.
# If the balance setting has been previously ad-
justed,
Balance will be displayed.
2 Push MULTI-CONTROL up or down to
adjust front/rear speaker balance.
Each time
MULTI-CONTROL is pushed up or
down, the front/rear speaker balance moves
towards the front or rear.
<CRD4089-A/N>48
Audio Adjustments
En
48
Section
11