Peripheral Electronics MEDIA GATEWAY PXAMG PGHNI2 - Manual (Page 19)

17
HD Radio Operation
Important Configuration Process
To ensure proper functionality of your HD tuner, you must first set the “TUNE” button
to the proper configuration. (Note: You do not have to repeat this process if you have
already done so for iPod control!) To do this you must first enter the Mode Select Menu.
Press the “RADIO” button a few times until “SAT” is displayed on the screen. Immedi-
ately press the “SCAN” button until “TUNEREV” is displayed. After 6 seconds the radio
will time out and the “TUNE” button is now configured properly.
Entering Mode Select Menu (2004-2005)
Press the “RADIO” button a few times until “SAT” is displayed on the screen. Immediately
press the “SEEK ▲” button to scroll through the available sources. Once “HD-FM” is
displayed, press the “TUNE ▼” button to select it.
Tune Up
Press the “TUNE▲” button to manually tune up.
Seek Up
Press the “SEEK ▲” button TWICE to seek up to next available station.
Tune Down
Press the “TUNE ▼” button to manually tune down.
Seek Down
Press the “SEEK ▼” button TWICE to seek down to next available station.
Changing Bands
Press the “AM/FM/SAT” button a few times until “SAT” is displayed on the screen.
Immediately press the “SEEK ▲” button to scroll through the available sources.
Once the band you would like to select is displayed (“HD-AM” or “HD-FM”), press the
“<<SEEK” button to select it.
Store Presets
Tune to a station you want to store. Press the “SCAN” button. Press “SEEK ▲” to
select the preset location (1-18) where you wish to store the preset. When the preset
location is displayed (for example PRE1) press “TUNE▲” button to store it. The screen
will display “PR SAVED” and your preset has been stored into memory.
Recall Presets
Press the “SCAN” button. Press the “SEEK ▲” button to scroll through the stored preset
stations. When the desired preset is displayed, press the “TUNE ▼” button to select it.
Exit menus
Press the “SCAN” button to exit the Preset Menu and continue playing the current
station. “EXIT” will be displayed when the button is pressed. You can also wait the
allotted 10 seconds and the menu will exit automatically.