Connecting the power cord, Preparing the remote control unit, Inserting batteries – Pioneer PDP-4270XA User Manual

Page 19: Operating range of the remote control unit, Preparation 05

Advertising
background image

Preparation

05

19

En

English

Note

• Disconnect the power cord from the power outlet when the plasma

television is not going to be used for a long period of time.

Connecting the power cord

Preparing the remote control unit

Inserting batteries

1 Open the battery cover.

2 Load the supplied two AA size batteries while inserting their

respective negative polarity (–) ends first.

Place batteries with their terminals corresponding to the (+) and (–)
indicators in the battery compartment.

3 Close the battery cover.

Caution

Improper use of batteries can result in chemical leakage or an
explosion. Be sure to follow the instructions below.

• When you replace the batteries, use manganese or alkaline ones.

• Place the batteries with their terminals corresponding to the (+)

and (–) indicators.

• Do not mix batteries of different types. Different types of batteries

have different characteristics.

• Do not mix old and new batteries. Mixing old and new batteries can

shorten the life of new batteries or cause chemical leakage in old
batteries.

• Remove batteries as soon as they have worn out. Chemicals that

leak from batteries can cause a rash. If you find any chemical
leakage, wipe thoroughly with a cloth.

• The batteries supplied with this product may have a shorter life

expectancy due to storage conditions.

• If you will not use the remote control unit for an extended period of

time, remove the batteries from it.

• WHEN DISPOSING OF USED BATTERIES, PLEASE COMPLY

WITH GOVERNMENTAL REGULATIONS OR ENVIRONMENTAL

PUBLIC INSTITUTION’S RULES THAT APPLY IN YOUR

COUNTRY/AREA.

Operating range of the remote control unit

Operate the remote control unit while pointing it toward the remote
control sensor (

t) located at the bottom right of the front panel of the

plasma television. The distance from the remote control sensor must
be within 7 m and the angle relative to the sensor must be within 30
degrees in the right, left, upward, or downward direction.

Europe, except UK and
Republic of Ireland

UK and Republic of Ireland

Power cord

Rear view

30 º

30 º

Remote
control
sensor

7 m

Advertising