Pioneer PDP-4270XA - Manual (Page 20)

Preparation 05
20
En
Caution
• Do not expose the remote control unit to shock. In addition, do not
expose the remote control unit to liquids, and do not place in an
area with high humidity.
• Do not install or place the remote control unit under direct
sunlight. The heat may cause deformation of the unit.
• The remote control unit may not work properly if the remote control
sensor of the plasma television is under direct sunlight or strong
lighting. In such case, change the angle of the lighting or plasma
television, or operate the remote control unit closer to the remote
control sensor.
• When any obstacle exists between the remote control unit and the
remote control sensor, the remote control unit may not function.
• As the batteries become empty, the remote control unit can
function within a shorter distance from the remote control sensor.
Replace the batteries with new ones early enough.
• The plasma television emits very weak infrared rays from its
screen. If you place such equipment operated through infrared
remote control as a VCR nearby, that equipment may not receive
commands from its remote control unit properly or entirely. If this
is the case, place that equipment at a location far enough from the
plasma television.
• Depending on the installation environment, infrared rays from the
plasma television may not allow this system to properly receive
commands from the remote control unit or may shorten allowable
distances between the remote control unit and the remote control
sensor. The strength of infrared rays emitted from the screen
differs, depending on images displayed on the screen.