Appendix i - specifications – Pride Mobility 1400 User Manual

Page 38

Advertising
background image

38 www.pridemobility.com Go-Chair

A P P E N D I X I - S P E C I F I C A T I O N S

Suspension:

Limited

Drive Wheels:

8 in. (20.32 cm), solid

Front Caster Wheels:

5 in. (12.7 cm), solid

Rear Anti-tip Wheels:

2 in. (5.08 cm), solid

Maximum Speed:

1

Up to 3.5 mph (5.65 km/h)

Range per charge

Up to 6 miles (9.65 km)

(Theoretical value based on Test Standards)

1

,

2

Range per charge:

Up to 8 miles (12.87 km)

(Value based on Straight-line Test Simulation)

1

,

3

Brakes:

“Intelligent Braking” electronic regenerative, disc park brake

Ground Clearance:

4

See figure 26.

Turning Radius:

4

See figure 26.

Overall Size:

4

Length: See figure 26.
Width: See figure 26.

Drivetrain:

Two motor, rear -wheel drive

Batteries:

5

Two 12-volt, 12 Ah, deep-cycle

Battery Charger:

2-amp, off-board

Weight Capacity:

250 lbs. (113 kg)

Component Weights:

6

Front Section: 22.5 lbs. (10.21 kg)
Rear Section: 34.5 lbs. (15.65 kg)
Seat: 25 lbs. (11.34 kg)

Batteries: 20 lbs. (9 kg) total weight of battery pack

1

Varies with user weight, terrain type, battery amp-hour (Ah), battery charge, battery condition, and tire condition. This specification

can be subject to a variance of (+ or -) 10%.

2

Tested in accordance with ANSI/RESNA, WC Vol 2, Section 4 & ISO 7176-4 standards. Results derived from theoretical calcu-

lation based on battery specifications and drive system performance. Test conducted at maximum weight capacity.

3

Tested by Pride Mobility Products under simulated conditions; continuous straight-line driving until total battery depletion. Test

conducted at maximum weight capacity.

4

Due to manufacturing tolerances and continual product improvement, this specification can be subject to a variance of (+ or - ) 3 %.

5

AGM or Gel-Cell type required. See IV. “Batteries and Charging.”

6

Battery weight may vary based on manufacturer.

NOTE: This product conforms to all applicable ANSI-RESNA testing requirements and ISO 7176 series

EN12184 standards. All specifications subject to change without notice.

GO-CHAIR SPECIFICATIONS

Advertising