Cabinet installation, Chassis installation into the cabinet, Instalacion del caja – Panasonic CW-C60YU User Manual

Page 10: Instalacion del chasis dentro de la caja

Advertising
background image

9

CABINET INSTALLATION

INSTALACION DEL CAJA

• Expand the expandable panel fully into the grooves of the

window frame, secure the expandable panel left and right
and top mounting frame to the bottom of the window
sash using 6 type A screws and 2 type C screws.

• Secure the cabinet using 2 type A wood screws.
• Cut the window sash foam seal to the proper size and

seal the opening between the top of the inside window
sash and the outside window sash.

Note : If a gap exists between the unit and window sash,

you may use “Sealer” supplied with the installation
kit for a better seal.

Window sash sealing ribbon

Cinta de sellado de la hoja
móvil

1 Cut the “Sealing Ribbon” to the proper length, and attach it along

the bottom edge of the bottom window sash.

1 Corte la cinta de sellar del largo apropiado y colóquela a lo largo

de la parte inferior de la ventana de guillotina.

3 Secure the cabinet using screws.
3 Fije la caja usando los tornillos.

Type A screw
Tornillo tipo A

Window sill
Alféizar de la
ventana

Type A screws

Tornillos tipo A

Expandable panel

Panel extensible

Type A screws

Tornillos tipo A

Type C screws

Tornillos tipo C

Inside of sash
Interior de la hoja móvil

Top bracket
Soporte superior

Sealing ribbon
Cinta de sellar

Window sash
Hoja de la ventana

Outside of sash
Exterior de la hoja móvil

• Expande el panel extenible completamente dentro del marco de la

ventana, asegúrelo a la parte inferior de la hoja de la ventana por la
izquierda, a la derecha y por la parte superior, usando 6 tornillos tipo
A y 2 tornillos del tipo C.

• Fije la caja usando 2 tornillos para madera tipo A.
• Corte la cinta para sellar de la hoja de la ventana del tamafío correcto

y selle la abertura entre la parte superior del interior y del exterior
de la hoja de la ventana.

Nota : Si existiera un espacio entre la unidad y la hoja de la ventana,

puede usar el sellador que está dentro del paquete de instalación,
para obtener un mejor sellado.

CHASSIS INSTALLATION INTO THE CABINET
INSTALACIÓN DEL CHASIS DENTRO DE LA CAJA

1 Slide the chassis into the cabinet
1 Deslica el chasis dentro del caja

2 To prevent condensation water from dripping inside, the cabinet

should be installed level or very slightly tilted to the outside.

2 Para prevenir que el agua de condensación gotee dentro, el caja

debe ser instalada al nivel o con una muy ligera inclinación desde
adentro hacia fuera.

9

Advertising
This manual is related to the following products: