3 management setting through terminal emulator, 1 system function, 1 software reboot – Planet Technology LCD MONITOR 170S8FS User Manual
Page 13: 2 factory reset, 3 image update, 2 configuration
10
11
4.1.3 Management Setting Through Terminal Emulator
There are three items in the Main Menu, System Function, Configuration and SNMP
Configuration.
4.1.3.1 System Function
There are three items in System Function menu, “Software Reboot, Factory Reset, and
Image Update.
4.1.3.1.1 Software Reboot
After configuring, it needs to reboot the software setting in order to run the device
properly.
4.1.3.1.2 Factory Reset
This function is to set the device back to the default setting in case of the messy setting.
4.1.3.1.3 Image Update
The section is to set the TFTP Server IP Address first, and the default address was set
to “192.168.1.2”. The Image File can be updated by uploading the image file from the
TFTP server.
Note: The content of the image file will write the whole firmware of the man-
agement module, please be sure that the image file is correct.
4.1.3.2 Configuration
To set the Software Reboot, Factory Reset and Image Update.