1 system function, 1 software reboot, 2 factory reset – Planet Technology LCD MONITOR 170S8FS User Manual
Page 19: 3 image update, 4 configuration update, 2 configuration, 1 general configuration
16
17
4.2.1 System Function
There are four items in System Function menu, “Software Reboot, Factory Reset, Image
Update and Configuration Update.
4.2.1.1 Software Reboot
Reboot the management module in order to run the new setting properly.
4.2.1.2 Factory Reset
This function is to set the device back to the default setting in case of the messy setting.
4.2.1.3 Image Update
The section is to set the TFTP Server IP Address first, and the default address was set
to “192.168.1.2”. The Image File can be updated by uploading the image file from the
TFTP server.
Note: The content of the image file will write the whole firmware of the man-
agement interface, please be sure that the image file is correct.
4.2.1.4 Configuration Update
The section is explaining how to upload and download the configure setting of the
management interface. The Configuration Upload is to restore a setting file to the
management interface. The Configuration Download is to backup the setting from the
management interface.
4.2.2 Configuration
There are five items in Configuration menu, General Configuration, System Configuration,
SNMP Configuration, Location Setting and Redundant Backup Setting.
4.2.2.1 General Configuration
Hardware revision: noted the version of the WMC-1600R.
BIOS revision: noted the version of the BIOS.
Firmware revision: noted the version of the firmware.
Change Password: the changing of the administrator password.
Confirm Password: to confirm the setting of administrator password.