Palsonic DVDR160G - Manual (Page 30)

Troubleshooting
25
Should your DVD recorder develop a problem, please check below before
requesting service:
Symptom Check and Action
No Power Check if the power cord has been properly connected to the power outlet.
Check if the main power has been switched on.
Does not play No disc, load a disc.
Disc has been loaded upside down. Place the disc with the label side up.
Disc's region code does not match to the player.
Disc is not correct type for the player.
Disc is damaged or dirty, clean the disc or try another disc.
There may be moisture condensation inside the player. Remove the
disc and leave the unit power on for one or two hours.
No Picture Check if the TV set has power on, use TV remote to select A/V signal for
DVD rather than broadcast.
Check if the system connection is secure.
Check if the connection cables are damaged.
Clean the disc.
Picture
noise / distorted
The disc is dirty or damaged. Clean the disc or try another disc.
Reset the colour system of the player or the TV set.
Try to direct the player to the TV set instead of via other components,
such as a VCR.
Picture not full
screen Select the screen format from the player's SYSTEM MENU,
see "SYSTEM MENU" of this manual.
Select the screen format from DVD disc menu.