Palsonic VCR9600 - Manual (Page 7)

.
Remote Control Operation
This VCR can be operated with the remote control from
up to a distance of about 23 feet (7 meters) and within an
angle of 15 degrees either side of center.
There must be no obstacles between the remote control
unit and the remote sensor of the VCR.
Battery Installation
Remove the battery cover on the rear of the unit.
(See Figure 1.)
Install two size “AA” batteries into the battery com-
partment. (See Figure 2.)
Close the battery cover. (See Figure 3.)
Fig. 1 Fig. 2 Fig. 3
Notes
Loading and Unloading
Loading
Insert a cassette tape with its labeled side up as shown
in the cassette compartment. The cassette will be auto-
matically drawn inside the compartment.
Unloading
Press the STOP/EJECT button. The cassette will be
ejected from the cassette compartment.
Remove the cassette by pulling it toward you.
To Prevent Accidental Erasure
Every video cassette has a safety tab to prevent
accidental erasure. Breaking off the safety tab is
recommended for prevention from accidental erasure of
the contents. If a tape without the safety tab is to be
reused, cover the gap with a piece of adhesive tape.
Be sure to install batteries properly to match the
polarity diagrams drawn inside the battery compart-
ment.
Do not mix a new battery with an old one.
Do not heat, disassemble, short or throw used batteries
into a fire.
Precautions on Use
Pressing two or more function buttons on the remote
control unit at the same time may result in improper
operation or damage.
Do not place the remote control unit in an area where
it may become wet.
Do not place the remote control unit near high heat.
Dropping the remote control unit on a hard surface
may result in damage.
Do not use benzene, thinner or other petroleum
based solvent to clean the remote control unit. To
clean, wipe a soft cloth slightly moistened with a mild
detergent, and then wipe dry with a soft cloth.
Video Cassette Tape
Only the video cassette tapes marked with can
be used in this VCR.
A cassette tape cannot be loaded or unloaded unless the
AC power cord is connected to the AC outlet.
Tape Speeds and Maximum Recording
Playback Time
TAPE SPEED
TYPE OF THE VIDEO CASSETTE TAPE
E-300 E-180 E-120 E-60
SP (Standard Play) 5hrs 3 hrs 2 hrs 1 hr
Care of the Video Cassette Tape
Avoid violent vibration or shock.
Do not place in a location where strong magnetic
fields exist (near a motor, transformer or magnet).
Never place or store in direct sunlight.
Avoid dusty places,
Place the cassette in the cassette case and store
vertically.
Never store tape in a humid location.
INTRODUCTION
E-4
.
.
.
.
.
.
.
.
.
.
.
.
.