ProForm PFEL64907.0 - Manual (Page 5)

5
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number
following the parentheses is the quantity needed for assembly.
Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it has been pre-assembled.
M10 x 127mm Button Screw (83)–2
M8 Nylon Locknut,
Bright (79)–1
M8 Washer
(88)–4
22mm x 16mm
Wave Washer
(111)–2
M8 x 23mm Button
Screw (84)–4
M8 Split
Washer (90)–3
M4 x 16mm
Round Head
Screw (101)–14
Hub Screw (87)–8 M8 x 15mm Button
Screw (116)–8
M8 x 69mm Button
Bolt (80)–1
M10 x 82mm Button
Screw (82)–2
M8 x 38mm Button
Screw (124)–6
23mm x 19mm
Wave Washer
(97)–2
M8 x 23mm x
1mm Washer
(112)–2
M8 x 16mm
Washer (110)–2
M8 Nylon Locknut
(78)–2
M10 x 58mm Shoulder
Bolt (71)–2
M8 x 23mm Shoulder
Screw (115)–2
M6 x 10mm Button
Screw (104)–8