Panasonic DMC-FX35 - Manual (Page 17)

17
VQT1P09
Preparation
1 Press [MENU/SET].
2
Press 3/4 to select [CLOCK SET].
3
Press 1 and then perform steps 3 and 4 to set the clock.
4 Press [MENU/SET] to close the menu.
•
You can also set the clock in the [SETUP] menu. (P20)
Note
• The clock is displayed when [DISPLAY] is pressed several times during recording.
• When a fully charged battery has been inserted for more than 24 hours, charging of the built-in
battery for the clock is completed so the clock setting will be stored (in the camera) for at least
3 months even if the battery is removed. (If you insert a battery that is not sufficiently charged,
the length of time that the clock setting is stored may become less.)
• You can set the year from 2000 to 2099. The 24-hour system is used.
• If the clock is not set, the correct date cannot be printed when you stamp the date on the
pictures with [TEXT STAMP] (P78) or order a photo studio to print the pictures.
• If the clock is set, the correct date can be printed even if the date is not displayed on the screen
of the camera.
Setting the Menu
The camera comes with menus that allow you to set the settings for taking pictures and playing
them back just as you like and menus that enable you to have more fun with the camera and use
it more easily.
In particular, the [SETUP] menu contains some important settings relating to the camera’s clock
and power. Check the settings of this menu before proceeding to use the camera.
Changing the clock setting (In normal picture mode)
[MODE] playback mode menu
(P32, 70 to 73)
A [REC]/[PLAYBACK] selector switch
• This menu lets you
select the setting of
the playback methods
such as playback or
slide show of only the
pictures set as
[FAVORITE] .
( [PLAYBACK] mode menu (P76 to 87) ! [REC] mode menu (P57 to 66)
• This menu lets you
make the rotation,
protection, trimming
or DPOF settings, etc.
of recorded pictures. • This menu lets you set
the coloring,
sensitivity, aspect
ratio, number of pixels
and other aspects of
the pictures you are
recording.
[SETUP] menu (P20 to 24)
• This menu lets you perform the clock settings, select the operating
beep tone settings and set other settings which make it easier for you to
operate the camera.
• The [SETUP] menu can be set from either the [REC MODE] or
[PLAYBACK MODE].
A
DMC-FX35P_mst.book 17 ページ ２００８年１月１５日 火曜日 午前１０時３６分