Pioneer Elite VSX-23TXH - Manual (Page 39)

Connecting your equipment 03
39
En
Connecting a USB device
It is possible to playback files using the USB interface on
the front of this receiver.
• Switch the receiver into standby then connect your
USB device to the USB terminal on the front panel of
this receiver.
• Push down on the PUSH OPEN tab to access the USB
terminal.
• For instructions on playing the USB device, see
Playing a USB device on page 48.
VSX-23TXH:
VSX-21TXH:
Plugging in the receiver
Only plug in after you have connected all your
components to this receiver, including the speakers.
1 Plug the supplied power cord into the AC IN socket
on the back of the receiver.
2 Plug the other end into a power outlet.
1
CAUTION
• Handle the power cord by the plug part. Do not pull
out the plug by tugging the cord, and never touch the
power cord when your hands are wet, as this could
cause a short circuit or electric shock. Do not place
the unit, a piece of furniture, or other object on the
power cord or pinch the cord in any other way. Never
make a knot in the cord or tie it with other cables. The
power cords should be routed so that they are not
likely to be stepped on. A damaged power cord can
cause a fire or give you an electric shock. Check the
power cord once in a while. If you find it damaged,
ask your nearest Pioneer authorized independent
service company for a replacement.
• Do not use any power cord other than the one
supplied with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
• The receiver should be disconnected by removing the
mains plug from the wall socket when not in regular
use, e.g., when on vacation.
• Make sure the blue  STANDBY/ON light has gone
out before unplugging.
• If you have connected speakers with a 6 Ω
impedance, change the impedance setting before
turning on the power.
MASTER
VOLUME
MCACC SETUP MIC USB
iPod iPhone
VIDEO CAMERA
HDMI 4
CONTROL ON / OFF
USB mass
storage device
MASTER
VOLUME
MCACC SETUP MIC USB VIDEO L R AUDIO
iPod iPhone VIDEO 2 INPUT
CONTROL ON / OFF
MCACC SETUP MIC USB VIDEO L R AUDIO
iPod iPhone VIDEO 2 INPUT
USB mass
storage device
Note
1 After this receiver is connected to an AC outlet, a 2 second to 10 second HDMI initialization process begins. You cannot carry out any
operations during this process. The HDMI indicator in the front panel display blinks during this process, and you can turn on this receiver
once it has stopped blinking. When you set the KURO LINK mode to OFF, you can skip this process. For details about the KURO LINK feature,
see KURO LINK on page 63.
VSX-23TXH_CUXJ.book 39 ページ ２００９年５月８日 金曜日 午前１０時４５分