Polaroid P100i - Manual (Page 21)

13
P100i
User’s Manual
General Information
Getting Started
Operation
Printing a Card
Cleaning
Troubleshooting
Specifications
Appendix A
Appendix B
Appendix C
Polaroid
C - CARD THICKNESS CONTROL LEVER
This item is operated by the user to prevent more than one card feeding
into the printer at the same time and causing a jam.
Open Cover, and adjust lever to correct
position. Repeat for different card
thickness.
(Factory setting is for 30mil (0.762mm)
card thickness). See diagram below:
D - CARD OUTPUT HOPPER
This item is used for collecting printed cards.
Install Card Output Hopper onto printer by
hooking over bottom edge of card exit
aperture.
Card Thickness:
A - 60mil (1.524mm) to 50mil
(1.27mm)
B - 40mil (1.016mm)
C - 30mil (0.762mm)
D - 20mil (0.508mm)
E* - Less than 20 mil (0.508mm)
* Start at lowest position and move
lever up to match card thickness.
For other card thickness, start lever at
lowest position and move up until
cards feed.