Panasonic DMC-LZ8 - Manual (Page 101)

101
VQT1L86
Connecting to other equipment
Motion picture playback on a PC
Use “QuickTime” (for Windows 2000/XP/
Vista) in the supplied CD-ROM when you
play back motion pictures recorded on this
camera on your PC.
Download [QuickTime6.5.2 for Windows]
from the following website and install it
on your PC when you use Windows98/
98SE/Me.
http://www.apple.com/support/
downloads/quicktime652forwindows.html
The software is a standard Macintosh
feature.
Folder composition
Folders appear as follows.
DCIM
MISC
100_PANA
101_PANA
999_PANA
P1000001.JPG
P1000002.JPG
P1000999.JPG
100_PANA
1
2 3
Built-in
memory
Card •
•
1 Folder number
2 File number
3 JPG : Pictures
MOV : Motion pictures
MISC: Folder containing fi les with following
settings
DPOF print
Favorite
This unit stores up to 999 picture fi les in
each folder. A new folder is created after
this maximum is reached.
To reset fi le and folder numbers, use
[NO.RESET] in the setup menu.
( P23 )
■
•
•
■
•
•
Conditions under which a different
folder number is used
In the following cases, the picture is
not recorded in the same folder as the
previously recorded picture. It is recorded
in a folder with a new number.
The folder containing the picture you
just shot had a fi le numbered 999 in it
(example: P1000999.JPG).
When the card just recorded to contains,
for example, a folder with the number
100 (100_PANA) in it and that card is
removed and replaced with a card that
has a folder with the number 100 in it
recorded by a camera from a different
maker (100XXXXX, with XXXXX being
the name of the maker) and then a
picture is recorded.
You start shooting again after using
[NO.RESET] in the setup menu. (It
is recorded to a new folder that has
a number following on from the one
previous. You can also reset the folder
number to 100 by using [NO.RESET]
immediately after formatting the card
when there are no folders or pictures on
the card.)
Connection in the PTP mode
If the OS is “Windows XP”, “Windows
Vista” or “Mac OS X”, you can connect
in PTP mode if you set the camera to
[PictBridge (PTP)] and press [MENU/SET]
after connecting the USB cable.
You can only load pictures from the
camera and cannot write them on the
card or delete them.
However, you can connect in MTP mode
on Windows Vista, instead of PTP. Then,
you can format or delete the data on the
card.
When there are 1000 or more pictures on
a card, the pictures may not be imported.
■
•
•
•
■
•
•